alarm problem 95 mazda

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=15935
Printed Date: July 19, 2025 at 3:22 PM

Topic: alarm problem 95 mazda

Posted By: amf17
Subject: alarm problem 95 mazda
Date Posted: July 06, 2003 at 12:43 PM

i just installed an alarm in my 95 mazda b2300. Ungo MS3001. It all seemed to be working fine but something is wrong with the driver side door switch. All the connections are good. After the alarm has been set for about an hour, it suddenly just goes off. I jumpered the "ignore delayed dome light" because in the diagram it shows that it is connected to the door trigger. I waited about an hour and the alarm didn't go off........ i thought it was fixed. But then i opened the driver side door and the alarm didn't go off at all.

Any help would be greatly appreciated

Thanks

Andrew

Replies:

Posted By: amf17
Date Posted: July 06, 2003 at 1:09 PM

I was reading aomething on this site after i posted this topic. Would i have to put diodes on the wires connecting the switches to the wire on my alarm????

Andrew

Posted By: Velocity Motors
Date Posted: July 06, 2003 at 7:30 PM

https://www.velocitymotorsport.com/images/install_notes/149.jpg

Use the above diagram 1 for a relay isolation of the door triggers to stop falsing of the system.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA