I posted earlier on the same subject and was very thankful for the help i got. Now i need just a few more things and I'll be in business.
I installed the security part of the system with no trouble at all. It detects all the zones (trunk and hood, doors, ignition and shock) and reports them correctly to the remote. However, the remote start will not work because I don't know where some of these wires go. Here's a list of the ones I can't figure out.
1. Pink on Remote Start Ribbon Harness: 200ma ignition relay turn-on:
2. Orange on Remote Start Ribbon Harness: 200ma accessory relay turn-on
3. Purple on Remote Start Ribbon Harness: 200ma starter relay turn-on
4. Green on Starter Kill Relay: No Idea what this does.....can't find it in install guide. In fact, I can't find anything about the starter kill relay in the install guide....my friend Ryan said that the yellow went to the ignition (seems right because that's the starter wire and they're both yellow) and that the black went to the main system ground.
Basically, what I need to know is what color the corresponding wires are in my saturn. Once these are hooked up properly, it should remote start (i already have the tach, brake and neutral safety wires connected).
Thanks for any help in advance!
-------------
Pimpin' a Saturn ain't easy!
i believe those wires are the harness that plug into the unit. you dont do anything else.
look at the heavy gauge diagram on p14
do like it says and correspond to your car wire
the starter relay you talkin about is attach to an orange wire off of harness H1. green and black are place at the starter wire after cut them.
the starter wire on the heavy gauge goes to the starter side of the wire that you cut.
i like your lil signature "slogan"
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).