Print Page | Close Window

Factory Disarm/Arm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=16132
Printed Date: May 25, 2025 at 9:26 AM


Topic: Factory Disarm/Arm

Posted By: Fullthrottle
Subject: Factory Disarm/Arm
Date Posted: July 10, 2003 at 4:21 PM

Any of you creative types out there find any other use for the factory disarm/arm output other then for its obvious purpose? Just curious!




Replies:

Posted By: Velocity Motors
Date Posted: July 11, 2003 at 12:37 AM

Use it for window modules to roll up or down when armed or disarmed.



-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA



Posted By: Fullthrottle
Date Posted: July 14, 2003 at 8:56 PM
Thanks!

Anyone else?



Posted By: JWorm
Date Posted: July 14, 2003 at 10:00 PM
One use of the rearm output...
On recent Toyota trucks if the owner leaves his lights on after shutting the truck off they automatically shut off when he opens the door to get out. If you remote start the truck with the lights in the on position and then shut the truck off by remote, the lights will NOT shut off until you open a door. There is not a built in timer like their should be (like GM vehicles have). Leave the truck overnight, and the lights kill the battery. Solution: Connect the rearm wire to a relay that sends a ground pulse to the drivers door trigger. Relay is needed because rearm output is usually too weak. I think this also applies to recent Mitsubishi vehicles.


Print Page | Close Window