Autopage Starter Kill Relay

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=16990
Printed Date: July 19, 2025 at 3:31 PM

Topic: Autopage Starter Kill Relay

Posted By: Creator_11
Subject: Autopage Starter Kill Relay
Date Posted: August 01, 2003 at 10:39 AM

I have an autopage rf-305 and it cam with a relay and wire harness, which i assume is for the starter kill, but it didn't come with a diagram of what each wire from the relay goes too. If anyone can help it would be greatly appreciated, ;)

Replies:

Posted By: jrilla
Date Posted: August 01, 2003 at 10:07 PM

3 wire relay harness I assume? Red goes to key side of the starter wire after you cut it, white goes to the starter side along with the starter output from the RS, and the orange goes to the (-) ground out when running wire from the RS. Look in your manual for that wire.

-------------
J Rilla

Owner/Installer

Posted By: Creator_11
Date Posted: August 03, 2003 at 3:47 PM

Ok so i wired up the relay, with 85 going to the alarm (-) output, then 86 to a constant (+), and then 30 to the starter wire going to the ignition switch, and 87a connected to the starter wite going to the starter.

When the alarm goes off, it still starts, i know i have the correct starter wire, cause when i cut it, the car would not start. I have also tried switching the wire between 30 and 87a, but it still starts when the alarm is going off, could the relay be broken, i can't hear a clicking from it when the alarm arms, but im not sure how loud a click noice should be.

I have a manual transmission, not sure if this makes a difference.

Posted By: elrayodesinaloa
Date Posted: August 04, 2003 at 6:30 PM

30 key side

87a motor side

85 true ignition

86 armed signal from alarm

-------------