Print Page | Close Window

Turn light ouput

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=17227
Printed Date: July 26, 2025 at 11:28 AM


Topic: Turn light ouput

Posted By: royarvind
Subject: Turn light ouput
Date Posted: August 06, 2003 at 6:36 AM

Got a new alarm. It has teo wires which says Turn Light (output +). I wanted to connect it to my Parking lights instead of indicators so I used only one brown wire to connect to my parking lights. Is it OK to do that because the alarm is not working. It does not flash light when arming but does flash when disarming. The LED doesnt work and the siren doent work too.



Replies:

Posted By: royarvind
Date Posted: August 06, 2003 at 6:37 AM
Sorry. It has two wires.......



Posted By: draasch
Date Posted: August 06, 2003 at 8:06 AM
what brand of alarm is it???

what is the car???


-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt




Posted By: royarvind
Date Posted: August 06, 2003 at 4:09 PM

The alarm is called Carscop. The car is Honda Ascot '93.

Do we need two + outputs for indicator or parking lights?

Thanks




Posted By: draasch
Date Posted: August 07, 2003 at 4:37 AM
did you double check to make sure you have all the wire hooked up. you might have to use both wires for the lights. check the rest of the wires...

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt




Posted By: royarvind
Date Posted: August 07, 2003 at 7:44 AM

Yeah all the wires are all right but the starter interrupt messed up so i took it out and the alarm itself is working fine. I had connected it following the diagram supplied in the manual.

According to the diagram

the lead frm 86 should go the cut relay (-) output frm the alarm

join 85 and 30 together and connect to Key ON

87A goes to +12v

I somehow feel its not right and would greatly appreciate any help.


Print Page | Close Window