starter interrupt

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=17302
Printed Date: May 31, 2024 at 11:17 PM

Topic: starter interrupt

Posted By: royarvind
Subject: starter interrupt
Date Posted: August 07, 2003 at 8:09 PM

Hi guys

i have got a starter interrupt with my alarm. Its an independent unit. Once i connected it I found out that my alarm was malfunctioning so I took it off and the alarm works fine. I connected the starter interrupt following the directions given in the alarm manual. They are as follows

According to the diagram

the lead frm 86 should go the cut relay (-) output frm the alarm

join 85 and 30 together and connect to Key ON

87A goes to +12v

I somehow feel its not right and would greatly appreciate any help.

Replies:

Posted By: cpgoose
Date Posted: August 08, 2003 at 9:03 AM

Hey....check out this page from the12volt.com, and compare your setup.

-------------
Q: What's the best nation in the world?
A: Donation! Donate to the12volt.com

Posted By: royarvind
Date Posted: August 08, 2003 at 9:43 PM

i have checked that. Could it be different depending on different alarms.

if not what are the small X in 87a and 30?

is ignition switch same to KEY ON?

which lead is for starter motor?

Posted By: elrayodesinaloa
Date Posted: August 08, 2003 at 11:56 PM

try this see if it works

86 armed input from alarm

85 true ignition

87a motor side of starter

30 key side from starter

87 not used

-------------

Posted By: royarvind
Date Posted: August 10, 2003 at 6:08 PM

Everything sorted out.

Thanks for your help guys.