Need help with remote start on 90 Jeep

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=17556
Printed Date: April 28, 2024 at 9:15 PM

Topic: Need help with remote start on 90 Jeep

Posted By: cerwinvega19
Subject: Need help with remote start on 90 Jeep
Date Posted: August 13, 2003 at 4:48 PM

Hey, I am installing a alarm and remote start combo, but the remote start only has an engine sensing wire not a tach sensing one. In the book it said " Engine sensing wire. Connect it with the generator sensing wire. Location method: Put the gearshift on neutral position first. This wire will show negative output (maybe 3-4V for some cars) when key ON, 12Voutput when start. It starts then shuts off 5 seconds after because this wire is not hooked up. When it starts i put 12v on the wire and it stays on. What wire should i hook up to it so it has 12v after it starts? I tryed to the acc, but that has 12v when cranking (Because of this alarm) so i can't use that.

Replies:

Posted By: cool_greg
Date Posted: August 13, 2003 at 5:28 PM

how about telling us the make and model of the alarm/RS and maybe someone else has installed one of these and can help you out

-------------
Just a Guy, Wiring up those Vehicals
---------------------------------
Gool_Greg

Posted By: cerwinvega19
Date Posted: August 13, 2003 at 8:42 PM

I bought it on ebay, it is not selling anymore the model number is kcjs-v12. there is not alot of info on the alarm, but basicly i just need an idea of what to hook this wire to. It has to be off during crank (start) and on when the engine starts, i was thinking accessory wire, but it has 12v when cranking and it stops cranking the engine before it actually starts.

What the remote looks like.