Passlock I - Will this work?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=17629
Printed Date: July 18, 2025 at 10:45 PM

Topic: Passlock I - Will this work?

Posted By: goldfinger
Subject: Passlock I - Will this work?
Date Posted: August 15, 2003 at 11:34 AM

I've been dealing with this silly thing for almost 2 weeks. I've beent through 2 bypass modules and neither of them seem to get the job done.

Someone told me I could buy a resistor within 5% and put it one end on the vehicle side of the yellow passlock wire and the other on the passlock ground for a permanent bypass. Will this work or are there other connections required like there is for the bypass module (IE bulb test)? I don't really care if Passlock is disabled all the time or not. If the above solution will work I had rather do that than then relay+resistor method.

Thanks

Replies:

Posted By: Velocity Motors
Date Posted: August 15, 2003 at 10:55 PM

You have to use the relay & resistor to permanently bypass the Passlock I system because the relay switches between the bulb test wire and the module side of the YELLOW wire.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: eurotek
Date Posted: August 16, 2003 at 9:04 PM

grab a passlok 1 module from DEI, the other ways eventually fail.. i had never seen the relay resistor, system work longer than a couple of months...

the "resistor" only bypass you are talking about only works on passlock II