Print Page | Close Window

529T in an unusual application

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=17670
Printed Date: June 26, 2025 at 9:19 AM


Topic: 529T in an unusual application

Posted By: MTXpert
Subject: 529T in an unusual application
Date Posted: August 16, 2003 at 11:22 AM

I want to use a 529T to open and close my electric cutout on my car (DC motor that opens and closes allowing full open exhaust or regular exhaust) automatically off of a full throttle 12V+ switch.

This is a regular 12VDC motor equivilant to a power window motor. I'm looking at the instructions and I came up with the following:

Green to positive side of motor

Blue to negative side of motor

Red - 12V+

Black - 12V-

And a relay hooked up :

85 ground

86 - 12v+ trigger from full throttle switch

30 ground

87 Orange

87A ORANGE / Black

This will cause the rest at ground on side A to close the cutouts then stop, 12V+ from full throttle switch will open the cutouts and keep them open until 12V+ is removed while not at full throttle. This won't be active all the time just when I close a switch allowing the 12v+ through to the relay.

Do I have this right?



-------------
Mike Bambic A.K.A. "The Bambinator"



Replies:

Posted By: MTXpert
Date Posted: August 16, 2003 at 4:59 PM

Well, that didn't work. I'm not even getting a test light to light for a second when it's hooked up that way...

Any ideas?

Mike



-------------
Mike Bambic A.K.A. "The Bambinator"




Print Page | Close Window