dei 530t problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=17798
Printed Date: June 21, 2025 at 11:42 PM

Topic: dei 530t problem

Posted By: rghrdr18
Subject: dei 530t problem
Date Posted: August 18, 2003 at 10:16 PM

i installed the dei 530t into a 96 eclipse gst. i hooked up all the wires except the grey wire. now the windows are hooked up to channel 4 on a dei viper550esp, that works fine. the only problem is that instead of the windows rolling up when i arm the system, they roll up when i turn off the ignition. what could be the problem? please help posted_image

Replies:

Posted By: sufferrar
Date Posted: August 19, 2003 at 8:46 AM

Check where you connected the orange wire in the 530t module. it should got to the negative when armed output of the alarm (orange wire on the alarm unit).

-------------
"I'm So Loud It Hertz"

Posted By: rghrdr18
Date Posted: August 19, 2003 at 9:35 AM

cool, i check that, thanks

Posted By: CutDog504
Date Posted: August 24, 2003 at 12:43 AM

I know exactly what yer problem is. You are getting feedback thru the starter kill relay. You need to diode isolate the starter kill relay from the orange wire on the 530t. To accomplish this task, you will need to connect a diode to the orange wire from the 530t, and put a diode on the orange wire coming from the starter kill relay. Make sure that the band side of the diode faces away from the starter kill raly, and away from the 530t. Tie together the 2 band sides of the diodes and connect this to the orange wire coming from yer alarm brain. So now you should have made a "Y" connection with th two band sides on the same side of the y facing the alarm brain.