Nissan 95 Ground when run
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=17863
Printed Date: May 28, 2024 at 4:08 PM
Topic: Nissan 95 Ground when run
Posted By: diep4554
Subject: Nissan 95 Ground when run
Date Posted: August 20, 2003 at 2:33 PM
Hi,
I am to locate the wire that show negative when running for Nissan Max 95? any help is greatly appreciated.
Replies:
Posted By: zargon
Date Posted: August 20, 2003 at 4:17 PM
negitive when running, please be a little more specific,tell me what you are hooking up and or what you are trying to do.
Posted By: jgstone
Date Posted: August 20, 2003 at 4:41 PM
agreed gotta have specifics
-------------
I like cars more than women, because their the perfect challenge.
___
______| \___
|_0___|____0_ }
Posted By: floaterr
Date Posted: August 21, 2003 at 12:52 PM
Thats the best idea but if your just doing some custom work you can hook up a relay to the ign wire. So it puts out ground when ign is on
85 = ign wire
86 = a ground to the body
30 = a ground to the body
87 = is your negative when ign is on. Relay pin out
Posted By: diep4554
Date Posted: August 21, 2003 at 7:15 PM
I appologize for lack of infor. I am trying to install DIRECT START 324 for Nissan Max 95. Everything is hooded up and it started smoothly but it's cutting off after about 60 seconds. dont' know why?? the only things I left out is "ground when running" on the relay of second starter. please help
Thank you
Posted By: jrilla
Date Posted: August 21, 2003 at 7:37 PM
Wow, 60 seconds is a long time for a car to run and then just shut off. I know those units fairly well too and I am pretty sure that the problem cannot be the tach wire since the unit doesnt monitor the tach continuously, but rather just long enough to make sure the car has started.
The second starter wire would not cause this problem either since that would only be a problem if the car didnt start at all.
Does the car shut off consistently after 60 seconds, every time you remote start the car? What tach wire did you grab?
-------------
J Rilla
Owner/Installer
Posted By: diep4554
Date Posted: August 22, 2003 at 2:50 PM
It's cranking for 3 seconds then start and running perfectly for 60 seconds and shut off completely. it does that every consistently. Not quite sure, could be WHITE/ green at ECM.
I know that something wrong at the timing and I try a few different way but no luck.
|