Print Page | Close Window

door trigger on 2001 Civic LX

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=18006
Printed Date: July 26, 2025 at 7:36 AM


Topic: door trigger on 2001 Civic LX

Posted By: kenmci
Subject: door trigger on 2001 Civic LX
Date Posted: August 24, 2003 at 12:46 AM

Okay I'm planning on putting in an alarm on my friend's civic.  I got the alarm wiring diagram, but it shows that there are three door trigger wires.  One for the Drivers door, one for the Passenger's door and one for the two rear doors.  I'm pretty sure that I have to connect all three of these wires to the door trigger on the alarm, but I just wanted to make sure that I should connect all three wires to the alarm brain.  Also I'm sure that I need to diode isolate each wire so that door chimes and etc. will work properly.  I believe that the side with the stripe should face away from the brain.  Is this correct?  I just wanted to double check on everything before I get started. 

Thanks in Advance.




Replies:

Posted By: draasch
Date Posted: August 24, 2003 at 7:00 AM
Dome Light GREEN/ RED (-) AT UNDER DASH FUSE/RELAY BOX **

** Optional Door Trigger Location 8 Pin Gray Connector Under Drivers Dash Above Kick Panel. GREEN (Dr), L GREEN/ RED (Ps) & GREEN / WHITE (Rear Doors) (-). Diode Isolation Needed, Cathode (Band) Side Of Diodes Face OEM Wires.

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt





Print Page | Close Window