I finally got around to installing my Aladdin 2000 on my 1992 Nissan 240sx.
I have a few questions now. I was able to get the remote start to work, I had to cut the brown loop and now it works except for when it starts after a few seconds it grinds. I tried to program the tach signal but I allways get the two beeps from my horn. I did check the tach wire, it reads 1.03~ at idle and the number goes up as the gas pedal is depressed. Also the two dip switches are up. I think if I hook it up to the alt. signal it would fix this. ??
When I am and disarm the alarm my doors do not lock or unlock. I'm under the impression that Nissan's have a 3 wire negative door lock setup. On the P9 plug the RED / BLACK wire is grounded and the P9 GREEN is connected to the GREEN wire in my door lock and the P9 BLUE is connected to the GREEN/ BLACK wire. Is this correct?
Any ideas? As you would have guessed my car is all apart and I need to get the Aladdin working asap.
Thank you for the help in advance.
Power Lock ORANGE / BLACK SINGLE WIRE - USES SINGLE RELAY
Power Unlock SINGLE WIRE USES SINGLE RELAY * #206
* Single Wire Door Lock System- Cut Wire,(Doors Will Lock), Switch Side To Pin #87A, Motor Side And Negative Unlock Output From Alarm To Pin #30. Negative Lock Output From Alarm To Pin #85. 12V Constant To Pin #86. Pin #87 Not Used
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt