must hold down button to arm/lock?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=18354
Printed Date: December 26, 2025 at 3:32 AM

Topic: must hold down button to arm/lock?

Posted By: mista2turbo
Subject: must hold down button to arm/lock?
Date Posted: September 01, 2003 at 7:42 PM

I am in the process of installing a Clifford Matrix 3. I have to hold down the button to arm the system and lock the doors. The unlocking/disarm works normally with just a single press of the button. Any ideas/suggestions?

Replies:

Posted By: jaxman
Date Posted: September 02, 2003 at 4:53 PM

Check the antenna wire.Check also the ignition.I think some wire keeps sending +12V after the engine it is off. Had this problem twice.

Print Page | Close Window