dome supervision

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=18871
Printed Date: May 14, 2025 at 8:22 AM

Topic: dome supervision

Posted By: majek
Subject: dome supervision
Date Posted: September 14, 2003 at 11:43 AM

How do you hook up the dome supervision for a 97 accord? I have a autoloc st9000 alarm, and why does the alarm have a dome light input wire and a dome light output wire? One more quetion how do you hook up the remote start, all the instruction says to do is hook one wire to the start point point of the ignition and hook the other wire to the side of the starter motor, but where to the side of the the stater motor. Please help me Thanks

Replies:

Posted By: c2deez
Date Posted: September 14, 2003 at 10:09 PM

Take the dome input wire and ground it, and take the dome output wire and connect it to the door trigger wire. Also, I'm confused about the remote start part. It sounds like you are trying to connect a starter disable(or at least that's what the instructions you're giving sound like) .

Posted By: Velocity Motors
Date Posted: September 15, 2003 at 8:02 AM

DOOR TRIGGER |blk/wht |- |gray plug right of column

The Honda uses a (-) trigger system where it rests at 12 volts + and when the door opens it grounds the circuit and engages the dome light. If the Autoloc uses a (-) dome light input take the input wire and hook it up to the dome light input wire. The dome light output wire is for a relay system and you can use this diagram for the output wire.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA