Print Page | Close Window

autopage rs-850 lcd

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=19038
Printed Date: May 16, 2024 at 12:34 PM


Topic: autopage rs-850 lcd

Posted By: almeida79
Subject: autopage rs-850 lcd
Date Posted: August 12, 2003 at 7:11 PM

Hello im looking for a installation/user manual for a autopage rs-850lcd remote car starter alarm  thanks in advance



-------------
Jay



Replies:

Posted By: almeida79
Date Posted: September 19, 2003 at 8:40 AM
Is there a way to make the autopage rs-850 lcd disarm itself automatically  when activating trunk release on the remote  because it triggers alarm as soon as you lift the trunk  lid is there a way to make it disarm itself  when you push the trunk release for two seconds to activate trunk popper so it does not trigger alarm.

-------------
Jay



Posted By: almeida79
Date Posted: September 19, 2003 at 4:19 PM
I guess the only way is to disarm and unlock doors first then press trunk release posted_image

-------------
Jay



Posted By: almeida79
Date Posted: September 20, 2003 at 9:26 AM
Another? does this also apply to the 750 lcd ?

-------------
Jay



Posted By: Derekc
Date Posted: September 21, 2003 at 8:09 PM

I think the AUTOPAGE RS_850LCD is same as COMMANDO FM-870 here:
https://www.commandocaralarms.com/itemdetails.asp?Productid=1185
Which is also the same as M-3600 (by Megatronix) promoted by WWW.ASIANWOLF.COM.

They all share the same brain and I have so much problem with this product.

The manual is here:
https://www.commandocaralarms.com/manuals/FM-870install.pdf



-------------
DC



Posted By: Derekc
Date Posted: September 21, 2003 at 8:10 PM

One of many problems I found when trying to install one (or two) of these AUTOPAGE / COMMANDO / MEGATRONIX M-3600 2-way pager LCD remote start alarm is this even the programming features specifically mentions you can set to disarm when activiating channel 3 (when is the trunk). It just doesn't work.

Other problems:

1. It gives a ground pulse on channel 4 and 5 when disarm. I have my windows rolling module hooked up to channel 4 and everytime it disarms, the front doors crack opens a bit.
2. The programming reset to default features (for both alarm and remote start) don't clear and reset anything.
3. Very short signal distance - about a block.
4. Very badly written manuals
5. .....



-------------
DC



Posted By: almeida79
Date Posted: September 22, 2003 at 5:34 AM
The feature you are programing is to disarm the cars factory alarm wich when programed it sends a neg pulse thru the disarm wire when you active the trunk release 

-------------
Jay




Print Page | Close Window