555u transponder bypass

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=19312
Printed Date: August 29, 2025 at 11:31 AM

Topic: 555u transponder bypass

Posted By: joedcrider
Subject: 555u transponder bypass
Date Posted: September 25, 2003 at 9:08 PM

I have no directions for this and can not fin them. If anyone can help the wires would be enough I think, unless there's more to it than what I see. I have a Ford Escape Using a DEI 555u bypass with a key for alpine 8063. It start if the key is by the ingintion. Is this all I need to make it work. What are these colors for

White

Blue

Red

And a black loop

Thanks to whom ever can help

and any additional tips would be appericiated

Replies:

Posted By: profuse007
Date Posted: September 25, 2003 at 9:34 PM

red - constant
blue - negative (from alarm)
white - not needed
the ring/black loop- goes around the key cylinder

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Posted By: NowYaKnow
Date Posted: September 25, 2003 at 9:37 PM

Not familiar with Alpine units but GENERALLY this is how you would hook up a 555U on most units. Cut the white off. Put the red to constant 12v and run the blue to your active out (-) OR ignition 3 (-) off the remote start. Take the shroud apart and put the black loop around the ignition cylinder. Hope that helps.

Posted By: Chris Luongo
Date Posted: September 26, 2003 at 7:16 PM

I didn't know Alpine made remote starts. Isn't the 8063 just an alarm? There is no need for a 555U without a remote start.

Posted By: joedcrider
Date Posted: September 26, 2003 at 8:22 PM

Thanks guys works great

Thanks again for the wire codes

Print Page | Close Window