93 Toyota Truck Keyless Entry

Hello,

          This my first post here. I have a 93 toyota truck sr5 with a codealarm pro 3000 on it. I not do the install. It was put in before I got the truck. to make a long story short, one of the wires from the codealarm box has come disconnected. it is labelled door locks (polarity). This truck has factory electric locks. I cannot determine where this wire needs to reconnect. I really am not sure exactly how it hooks to the lock circuiit. when I ground the wire and hit the "disarm" button, the locks will unlock just fine.  It does not seem to do anything when i push the "arm" button. A voltmeter across that wire and ground  does not give any reading either. I would really appreciate any help you could offer.

       Kind regards,

                                 Kevin

Try to look for another wire that has the negative polarity when you are arming it. Here are some wire info for your truck:

POWER LOCK             blue/white           ( - )   door control relay       |
POWER UNLOCK       blue / YELLOW          ( - )   door control relay       |

hope this helps.

hi,

 ken ,make sure you found the right lock wire in the truck, this wire is a blue/white  loacted behind the drivers speaker in the door lock control module.

  sounds like you have the wrong door lock wire for the car. you have it correct at the alarm, you grounded the polarity wire, this is fine, but locate the right lock wire and go from there!!

  good luck

   chris

Thanks for the replies. I figured it out. I had a bad ground to the alarm box. go figure.

Thanks again

Kevin