Print Page | Close Window

88-92 mazda mx-6 remote starter

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=1974
Printed Date: July 13, 2025 at 1:53 PM


Topic: 88-92 mazda mx-6 remote starter

Posted By: SCOTT105
Subject: 88-92 mazda mx-6 remote starter
Date Posted: July 15, 2002 at 10:42 PM

I WOULD LIKE TO PUT A REMOTE STARTER ON THIS VEHICLE BUT IT IS A STICK(5-SPEED). HOW WOULD I GO ABOUT WIRING IT TO START THE VEHICLE BEING THAT U USUALLY HAVE TO SINK THE CLUTCH TO START THE VEHICLE...



Replies:

Posted By: Velocity Motors
Date Posted: July 16, 2002 at 1:13 AM

The clutch has two wires attached to the pedal. One is for the clutch activation and the other is for cruise disengage relay. All you have to do is find the correct wire ( I'm not sure on these vehicles ) and hook up a 12 volt or ground signal to it when you activate the remote start option. You can use the STARTER output if the clutch requires a 12 volt + input or if it requires a (-) input you can use the Ground out when running wire to activate the clutch.



-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA


Print Page | Close Window