99 Durango remote lock connections

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=19825
Printed Date: July 18, 2025 at 7:06 AM

Topic: 99 Durango remote lock connections

Posted By: D.Kahler
Subject: 99 Durango remote lock connections
Date Posted: October 08, 2003 at 11:50 AM

I am adding a remote starter with keyless entry to a 99 Durango. It has the factory keyless entry and according the the wiring guide I should wire it as 3 wire positive, but other guides that I checked said that it is only reverse polarity. Anyone ever do this same install? If so what did you do and where is the best place to make the connections? I think I found the wires, coming off of a connector in the drivers kick panel, but they are tucked in tight and will be hard to tap into.

Replies:

Posted By: toadia
Date Posted: October 08, 2003 at 12:12 PM

this car uses + pulses in the driver kick pannel blue plug. ORANGE / purple for lock and pink/purple for unlock. hope this helps

Posted By: D.Kahler
Date Posted: October 09, 2003 at 11:06 AM

After much confusion I finally did find the wires. Problem was that the emergency brake mounting bracket was blocking my view of where the wirescame into the passenger compartment from the door. I finally traced it to the bundle of wires that run down the kick panel and past the drivers seat. I cut into this bundle and found my wires. Never did find the blue connector though and the 3 wire positive connection was correct. Thanks.

Print Page | Close Window