Alarm & Autostarter Help Needed

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=1992
Printed Date: July 12, 2025 at 3:07 PM

Topic: Alarm & Autostarter Help Needed

Posted By: Flynn380
Subject: Alarm & Autostarter Help Needed
Date Posted: July 16, 2002 at 8:06 PM

Good Evening,

I have a Rage II Model CS-9709DC Car Alarm I am going to be installing and I also have an Autostarter already installed. I need help with questions concerning which wires to connect the alram and the autostarter. There is a wire that came with the autostarter that allows you to connect it to the alarm but I have no idea where to connect it to on the alarm control box. The intructions on the autostarter say to connect the wire to the second or third pin channel (-) output of the alarm. But the intructions for the alarm have no instructions on which wire to connect this one to. Any help would be appreciated. If I have totally confused you I apologize. Thanks in advance for any help.

Flynn380

Flynn380@yahoo.com

Replies:

Posted By: -=Jason=-
Date Posted: July 16, 2002 at 9:41 PM

I'm not totally sure, but I'm thinking you could run the autostart off of an aux output from your alarm. would this work or do I need some sleep? :)

JASON

Posted By: dan768
Date Posted: July 16, 2002 at 10:37 PM

The remote start unit needs a neg. input to start,you need to test all the pins coming off alarm,look for a pin that shows a momentary neg.when the optional button on your remote is depresed(you may have to hold it dwn. for a few seconds). This will be the output to the remote starters neg. input.

-------------
dan
Remember (there are no hard cars,some just take longer to install on then others)