96 rodeo tailgate pop
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=19989
Printed Date: May 20, 2024 at 5:31 PM
Topic: 96 rodeo tailgate pop
Posted By: fatjoerules
Subject: 96 rodeo tailgate pop
Date Posted: October 12, 2003 at 10:03 AM
hello, i recently installed a clifford RSII alarm/remote start in my rodeo, but i couldn't find the tailgate pop control. the wire listed here (light green) is actually the feedback wire from the tailgate. when i hooked it all up to that wire, it just turned on the cargo light for a second. everything works except this and i know that if i bag on this now, it'll never get done. so does anyone know where this wire is and its color? thanks in advance. Andrew LeBlanc
Replies:
Posted By: godsegoizhuge
Date Posted: October 12, 2003 at 10:55 AM
Did you try to find the wire by the tailgate pop switch? You should find it there or maybe even at the relay that controls the pop feature. You just gotta keep poppin' the switch and listen for the relay clicking.
Posted By: fatjoerules
Date Posted: October 12, 2003 at 5:11 PM
yeah, i tried that, but theres 6 wires going into the switch. i even opened up the tailgate to find the wire, but again found 6 wires, and couldn't trace them back to the front too easily. theres no relay with the switch on the dash - only sound is the actuator.
Posted By: fatjoerules
Date Posted: October 14, 2003 at 12:47 PM
anyone?? Bueller??
Posted By: mazdatruckin
Date Posted: October 15, 2003 at 4:49 PM
1996 Isuzu Rodeo For trunk look for a gray or reb/blue wire at the release switch in the dash, throw a (+) pulse to this wire and all should be good. A lot of wiring diagrams here are wrong...
Posted By: mazdatruckin
Date Posted: October 15, 2003 at 4:51 PM
Light green is just the trigger wire, if you wanna pop the trunk use the wires i said above, i also meant RED / BLUE They should be right behind the switch, make sure it's a (+) pulse because most aux channels are (-), use a relay.
Posted By: fatjoerules
Date Posted: October 19, 2003 at 1:23 PM
thanks man i'll give that a try. Andrew
|