Starter Cut Relay ? in a 2002 Jeep Wrangler

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=2012
Printed Date: May 08, 2025 at 9:34 AM

Topic: Starter Cut Relay ? in a 2002 Jeep Wrangler

Posted By: SOtC
Subject: Starter Cut Relay ? in a 2002 Jeep Wrangler
Date Posted: July 17, 2002 at 8:59 AM

Thanks for any help you can give. I am installing an Alpine SEC-150R alarm in a 2002 Jeep Wrangler. The question I have is with the wiring of the Starter Cut Relay. It has 2 wires that connect to the Main Unit (Yellow-Ignition, ORANGE / Black-Starter Cut Output) and 4 wires that connect to the Starter/Ignition, where I have the questions.
I planned to use the Normally Closed Starter Interrupt, does that mean I leave the RED / White wire unconnected?

Where do the following wires connect on a 2002 Jeep Wrangler?

Yellow – Ignition [I am assuming this connects to the Jeep’s Blue ignition wire.]

Red- To Key(30) [?]

RED / White – Normally Open Connection (87) [?]

RED / Yellow – Normally Closed Connection (87A) [?]

Thanks! J

Replies:

Posted By: Big Dog
Date Posted: July 17, 2002 at 1:00 PM

Hey SOtC,

Yeah leave the RED / WHITE disconnected and the YELLOW is ignition. The RED on pin 30 goes to the yellow starter wire at the key side and the RED / YELLOW (87a) goes to the other end of the yellow starter wire that was cut towards the engine. posted_image

-------------
Prepare your future. It wasn't the lack of stones that killed the stone age.

Posted By: SOtC
Date Posted: July 17, 2002 at 8:25 PM

Thanks Big Dog! posted_image

I think it's all coming togther now!

SOtC posted_image