wiring prox. sensor to a 4 plug shock sen

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=20289
Printed Date: April 29, 2024 at 11:25 PM

Topic: wiring prox. sensor to a 4 plug shock sen

Posted By: quixs1lver
Subject: wiring prox. sensor to a 4 plug shock sen
Date Posted: October 18, 2003 at 10:12 PM

i got a clifford proximity sensor. and i have a pyhton 3000esp alarm installed...on the clifford website site it say i need to connect the the ORANGE wire to a piezo sensor. (RED / ORANGE / black). however i do not a have piezo but a dual stage sensor. which has 4 wires (red12+ black(-) and blue and green wires for the actual out put from the sensor. how which wire would i connect the prox. sensor to? oranga to -> blue or green?

Replies:

Posted By: misterjimbo
Date Posted: October 18, 2003 at 10:45 PM

is your prox a 508d?

-------------

Posted By: rudbwoy69camaro
Date Posted: October 18, 2003 at 10:45 PM

I had it on carsound.com. I can't access the forum there.

posted_image

Would this answer your question?

-------------

Posted By: quixs1lver
Date Posted: October 18, 2003 at 10:50 PM

i actually have the clifford proximity sensor 4. and here the diagram. it orange is connected to the 3 wire piezo sensor.

https://www.clifford.com/guides/wiring/proximitysen4_wiring.pdf

Posted By: misterjimbo
Date Posted: October 18, 2003 at 10:51 PM

green is the first stage or pre warn blue is the second stage or full alarm trigger. if you are going to run bothe the shock and proximity you should diode isolate them from one another to avoid interference. does your alarm have a trigger that you are not using? try hooking the second stage to it that way you can use your zone identification to see what sensor went off while youwere away.

-------------

Posted By: quixs1lver
Date Posted: October 18, 2003 at 10:54 PM

orange in INNER SENSOR

BLUE is OUTER sensor.

Posted By: quixs1lver
Date Posted: October 19, 2003 at 10:27 PM

so ok the BLUE wire to the GREEN for FIRST STAGE.

and

ORANGE to the BLUE second which is going to set of the alarm

cool thanks

Print Page | Close Window