Print Page | Close Window

Passlock II - Flashing Security Light

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=20311
Printed Date: May 23, 2024 at 11:46 AM


Topic: Passlock II - Flashing Security Light

Posted By: jeffmann
Subject: Passlock II - Flashing Security Light
Date Posted: October 19, 2003 at 4:23 PM

Apparently, I matched the wrong resistance when bypassing the passlock system. So now the security light is flashing which means the car won't start.

My question is, now that I have removed my passlock bypasser, how do I reset the "security light?" Do I just leave the key in on ON for a half hour like I have read, or is there a reset switch somewhere?

Pontiac Grand AM 03'

-JMann



Replies:

Posted By: jeffmann
Date Posted: October 19, 2003 at 4:30 PM
Well, leabing the key in for about 10 minutes fixed the flashing security light, I am now just trying to match the resistance values corectly.

-JMann



Posted By: Alpine Guy
Date Posted: October 19, 2003 at 5:30 PM
make shure the engine is running when you are taking your readings.



Posted By: HamiltonAudio
Date Posted: October 19, 2003 at 6:40 PM

are you using one of those dip-switch setting units that run in series with passlock?  if so, I'd advise against it.  two in a row were TOWED back to the shop a few seasons ago cause the unit failed, and took out the passlock signal, so the car didn't even run with the key.

we now use either PL2003 or PLDATA (whichever is most available from suppliers), as they merely "tap into" the passlock system, and don't run "between".  if it ever failed, remote start wouldn't work, but the key would.  MUCH happier that way!!  PLDATA won't work on cavaliers and sunfires....PL2003 works on everything passlock I and II...

b




Posted By: whiteshack
Date Posted: October 29, 2003 at 10:52 AM
turn key on until pass lock light stops blinking then close door lock with factory remotes if equip.or key then open door and start car.

-------------
mecp certified installer



Posted By: bear80
Date Posted: October 29, 2003 at 4:55 PM
where do you find a pl2003 or pldata at . is there a wed site to get them


Print Page | Close Window