Print Page | Close Window

Command Start CS2400

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=20928
Printed Date: April 29, 2024 at 9:25 AM


Topic: Command Start CS2400

Posted By: CLangan
Subject: Command Start CS2400
Date Posted: November 03, 2003 at 7:36 AM

Hello,

I have a Command Start CS2400 and transmitter CS-306. The problem I have is that when I press any button nothing happens. I do hear nose coming from the transmitter. How do I program the transmitter. I do have another one that works fine so I know the unit is find.

THanks

Clinton




Replies:

Posted By: Justaguy
Date Posted: November 03, 2003 at 6:43 PM
to program a new remote, flash(press the hood pin switch down and release, and then imediatly after, tap it quickly) the pin switch, make sure the lights stay on for atleast 5 or 6 seconds, then hold button one until the lights go out. close the hood.



Posted By: CLangan
Date Posted: November 07, 2003 at 11:11 AM

Thanks for the reply; Unfortually I still can't get it working. What happens is I press down the switch and the lights come on for 5 seconds and then goes off. I can't get the lights to come on soild. I do press the switch and then tap it quick but nothing. Any other suggestions

Thanks

Clinton




Posted By: Justaguy
Date Posted: November 07, 2003 at 10:29 PM

Keep trying, it's tricky. as soon as you release the switch, tap it all the way down and back really quick.

it'll work, trust me.



-------------



Posted By: CLangan
Date Posted: November 10, 2003 at 8:05 AM

THanks,

Yes your correct, it's tricky and I finally got it.

Thanks again

Clinton




Posted By: CLangan
Date Posted: January 19, 2004 at 8:39 AM

Hello,

My command start failed and now flashes 9 times. I have seen that you just disconnect the battery terminal and this will clear the code.

This can't be the only way of clearing the code. Does anyone know if there is a way using the engine switch and the remote control. I have seen this done before but can't remember.

Thanks

Clinton


Print Page | Close Window