Door Lock Problems

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=21378
Printed Date: May 17, 2024 at 8:37 AM

Topic: Door Lock Problems

Posted By: watchdog
Subject: Door Lock Problems
Date Posted: November 12, 2003 at 2:39 PM

Hi,

I rescently installed a Prostart 3300 on my Ford Escape XLT 2001. When I press the lock or unlock button on either the Prostart remote or the factory Ford Remote, all doors will lock and unlock except the Drivers side door.

Any suggestions.

Thanks

Replies:

Posted By: vaderfop
Date Posted: November 12, 2003 at 3:02 PM

Are you sure there is not something wrong inside your driver's door? You might want to check that out just to be sure. Does the inside lock work? Power lock?

Here is the wire info (just to double check):Should be both lock and unlock wires going to the same wire (pink/white at DKP or 26 pin plug @ GEM). Lock requires a 1000 Ohm resistor with a (-) negitive pulse and unlock just requires a (-)negitive pulse.

-------------
Remember check all your wires with a DMM!

Posted By: watchdog
Date Posted: November 12, 2003 at 3:19 PM

No, the inside door lock does not work either ( Drivers Door )

I did not use any relays for this hook up. Followed information on this website, and used Yellow/Red for unlock, and ORANGE / Black for lock.

Print Page | Close Window