1996 4runner remote starter
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=21419
Printed Date: July 13, 2025 at 5:16 AM
Topic: 1996 4runner remote starter
Posted By: seyemoreb
Subject: 1996 4runner remote starter
Date Posted: November 13, 2003 at 8:08 AM
I just purchased a crimestopper 999 for my 96 4runner. The install looks to be really straightforward, but on I have two small problems. (1) I need to locate the tach wire. (2) What is the "Correct" place to connect the 12v+. I wanted to know if most people connect to the battery or the ignition harness. I just want a trouble free installation. Thank you for any help. Steve
Replies:
Posted By: profuse007
Date Posted: November 13, 2003 at 9:36 AM
-for tach, most of toyotas have a black wire on a diagnostic port under the hood and/or under the dash.
if youre not able to grab a tach from those place, try to get from the igniters.
-for 12volt, i would go straight to the ignition harness, quicker install. i dont know about others, i think they would hate to feed a wire through the firewall. remember to fuse, very crucial if youre tapping into an existing wire.
-but the "correct", if you want to call it that, way is to go with the battery. you want to power it independent.
hope this give you some idea
------------- Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: Haku
Date Posted: November 13, 2003 at 12:40 PM
Profuse is correct, you have two 12V input wires on the rs-999, get them off the ignition switch harness. Theres usually two 12V constants, use one per/wire. If you run into any problems, post again. I install the Crimestoppers, and have the RS-999FM in my own truck. ------------- Hak
Siemens Autostart
|