remote start 2000 jeep cherokee
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=21475
Printed Date: May 28, 2024 at 1:26 PM
Topic: remote start 2000 jeep cherokee
Posted By: tjbhoward
Subject: remote start 2000 jeep cherokee
Date Posted: November 14, 2003 at 7:36 PM
I just installed an Audiovox remote start/ keyless entry on my 2000 jeep cherokee. The lock/unlock function works via remote but the reciever will not even recognize the "remote start" command via remote. Any suggestions? Thanks
Replies:
Posted By: cwagner17
Date Posted: November 15, 2003 at 12:59 PM
What Audiovox system did you install?
Posted By: tjbhoward
Date Posted: November 15, 2003 at 3:32 PM
It was the Audiovox AARS-5CS Remote Start and Car Finder
Posted By: Velocity Motors
Date Posted: November 15, 2003 at 5:35 PM
Did you program the tach as well as install the hood pin wire ? Does the Jeep even attempt to start ?
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: tjbhoward
Date Posted: November 15, 2003 at 7:10 PM
I broke the hood pin switch during install, but did connect to the positive on the underhood light. The tach wont program. The system acts like the control switch is off in both positions. ( It doesn't do anything at all when given the remote start command via remote.) Thanks for all the input so far.
Posted By: profuse007
Date Posted: November 15, 2003 at 8:10 PM
audiovox have a switch thats need to be complete(plug in the switch). unlike DEI theres a initiate ground wire on the main harness, audiovox have this switch you need to plug in.
good luck, post your result....
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: tjbhoward
Date Posted: November 16, 2003 at 10:57 AM
I fixed it!! I was on the wrong hood light wire. Thanks for all the help.
Posted By: tjbhoward
Date Posted: November 22, 2003 at 8:53 PM
I installed an audiovox remote start on a 2000 jeep cherokee and now something is draining the battery. Everything was working but the morning after the install the battery was dead and it wont hold a charge. Any ideas about what could cause this? Thanks Tommy Howard
Posted By: jrilla
Date Posted: November 22, 2003 at 11:08 PM
Did you install an anti-grind relay?
How did you interface the doorlocks? databus interface module or relays?
What bypass module did you use if you have a gray key?
Did you power two devices using a single (-) out when running wire? You should always diode isolate the devices when doing so.
-------------
J Rilla
Owner/Installer
|