Print Page | Close Window

Entering Alarm Into Program Mode

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=21526
Printed Date: September 15, 2025 at 7:22 AM


Topic: Entering Alarm Into Program Mode

Posted By: NateDG
Subject: Entering Alarm Into Program Mode
Date Posted: November 15, 2003 at 7:17 PM

I have this alarm that won't seem to go into program mode. I am trying to get the valet switch to put the alarm in valet mode instead of just setting the alarm off which the brain came factory set at. The instruction booklet is absolutly worthless and all the "pros" around here just keep telling me I have a crappy alarm which is true but everything else about it works just fine. The book says to switch it to switched valet mode I must have the door open and the ignition turned on and then press and release button 3, 2, 1, 2 Then it's supposed to blick and chirp to confirm but nothing ever happens. I have a cyborg-IV alarm made by Hitron security systems. It's a cheapy but everything else seems to work fine so I don't know if I'm missing a step or what. If someone could look into this or maybe has a solution as to how I can bypass this all-together by wiring something, please let me know. Any help would be greatly appreciated.



-------------
-Nate



Replies:

Posted By: profuse007
Date Posted: November 15, 2003 at 8:04 PM
check to see if you plug the valet button in the wrong oulet?
happen to me once with a used prestige.....

see if that help

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).



Posted By: NateDG
Date Posted: November 15, 2003 at 10:15 PM
There is no outlet for the valet switch, only a single wire that comes out of the 23(?) pin harness

-------------
-Nate


Print Page | Close Window