Print Page | Close Window

? on keyless install

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=21650
Printed Date: July 09, 2025 at 7:24 PM


Topic: ? on keyless install

Posted By: elkie
Subject: ? on keyless install
Date Posted: November 19, 2003 at 12:23 PM

Just a few ?s on installing my keyless entry system.

All parts of the install are pretty much straight forward with no problem. Except for how to hook up the wires(doesn't explain at all, beside what each wire goes to).

I have 2 wires that are to go to a constant 12v source. But one is for polarity, while the other is not, Can those 2 wires be hooked together at one power source?

Second there is about 4 or 5 wires that has to go to chasie ground. Can I hook all these wires to one grounding spot on the frame? Or due I have to hook each wire up by itselt to a ground?

Third,  Where is the best place under the dash to place the brain for the system? To get the best signal for the wireless part. I was thinking on the drivers side of the truck, or possible behind the glove box area of the truck

Thanks for you help guys!!!




Replies:

Posted By: cwagner17
Date Posted: November 19, 2003 at 4:43 PM
What type of system are you installing?



Posted By: elkie
Date Posted: November 19, 2003 at 10:10 PM

It's made by IC Dynamics,    and it's the keyless entry with the 2 actulators in the kit.


Print Page | Close Window