2004 excursion dsl. need help

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=21691
Printed Date: June 08, 2024 at 9:31 PM

Topic: 2004 excursion dsl. need help

Posted By: n2hvq
Subject: 2004 excursion dsl. need help
Date Posted: November 20, 2003 at 1:16 AM

need to find colors and location for tach. sensor wire, and wait to start (glow plug sensor) wire.

-------------
n2hvq

Replies:

Posted By: misterjimbo
Date Posted: November 20, 2003 at 5:49 PM

for the tach use the lt green white it is taped to a thick wire harness and there are four other wires there as well. the harness is behind the fuse box and to the left a little. i never use the wait to start light because all the units i use have a wait to start function in the menu.

-------------

Posted By: birdondubthreez
Date Posted: November 21, 2003 at 12:20 PM

You can go to any igniton coil and use the wire that is NOT red-light green or you can go right behind the hood release there is 4 wires taped behind that. As far as the wait to start there isnt one you will have to use dei part# 528t and the following diagram. https://www.directechs.com/techtips/pdfs/resources/security/directed_techtips/1091.pdf

-------------
BiRdOnDuBtHrReEz

Posted By: n2hvq
Date Posted: November 21, 2003 at 8:33 PM

Thanks very much for the reply...will try those colors....start module has delay avail. but it is excessive on the new 6L diesel. when warm no delay needed (hardly 1sec.)

Much appreciation

-------------
n2hvq

Posted By: birdondubthreez
Date Posted: November 22, 2003 at 1:18 PM

With the pulse timer relay it will allow you to adjust it from 0 to 90 seconds

-------------
BiRdOnDuBtHrReEz

Print Page | Close Window