Print Page | Close Window

Blown fuse on entry light

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=21700
Printed Date: May 15, 2025 at 5:53 AM


Topic: Blown fuse on entry light

Posted By: germanspec
Subject: Blown fuse on entry light
Date Posted: November 20, 2003 at 9:13 AM

I have installed an alarm system on a 1995 GMC Yukon, and,  I am blowing the fuse for the dome lights.  It didnt blow the fuse right off the bat, it seemed to take a day, then it started blowing fuses.  The system had me install a relay for dome light supervison, so when the doors unlocked, it turns on the light for 30 sec.  But, in the owners manual, not the installers manual, it mentions that if the truck HAS dome light supervison already on it, which I assume it does, as when I use the GMC remote to unlock the doors, it turns on the light inside, the owners manual says do NOTconnect the dome light wire if your vehicle already has dome light supervison, might this be the reason its blowing the fuse?

Thanks




Replies:

Posted By: avxtech
Date Posted: November 20, 2003 at 4:00 PM
What wire did you connect to in the truck? And where in the truck did you get it from?  How did you wire your relay?


Print Page | Close Window