1995 dodge pickup door locks

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=21742
Printed Date: May 15, 2025 at 5:58 AM

Topic: 1995 dodge pickup door locks

Posted By: yerav
Subject: 1995 dodge pickup door locks
Date Posted: November 21, 2003 at 6:59 AM

I have a 1995 dodge 1500 ext.cab. I installed a ct 3300 remote start with a neg. door lock out put and I am not sure of what wirs or how to hook up door locks. All help would be appreciated. Thank You

Replies:

Posted By: avxtech
Date Posted: November 21, 2003 at 10:11 AM

Hi, the locks in that truck are a 5-wire reverse polarity which requires the use of 2 relays. These wires are pink/violet(unlock), ORANGE / violet(lock) and can be found in the drivers kick, or pass. kick. The diagram to wire these relays up are usually included with the alarm install guide. Or follow this:

Locate the 2 Lock wires, cut them in half. One side of the wire is your motor side , and the other side is the switch side.

85&87- 12 volts constant (fused!)

86- lock output from alarm.

30- Lock side of the cut wire

87a- switch side of the cut wire

****If you blow the fuse on your relays, reverse the wires on 30 and 87a****

Good luck, hope this helps.

Posted By: yerav
Date Posted: November 24, 2003 at 2:16 AM

I have a 95 dodge ram with power door locks. They are 5 wire locks and the auto start remote has a neg. wire for lock and unlock. How do I hook the wires up so I dont blow fuses. Thanks

-------------

Posted By: sroth140
Date Posted: November 24, 2003 at 2:20 AM

youll have to use two relays, or get a dei 451m.

posted_image

youll have a switch side that will show 12 volts all the time, and a motor side that will show nothing. you can go to directed.com and get the manual for the 451m and follor that too.

Posted By: yerav
Date Posted: November 27, 2003 at 12:34 AM

I have a 95 dodge ram pick up with factory locks. And I have a remote starter with { - } output for lock and unlock. Do i need relays and if so how do I hook the up. Thanks

-------------

Posted By: chriswallace187
Date Posted: November 27, 2003 at 1:55 AM

Use the following for your lock hookup. You will need relays. https://www.the12volt.com/doorlocks/page3.asp#5w

Posted By: HamiltonAudio
Date Posted: November 27, 2003 at 7:57 AM

instead of building your own harnesses, you can get pre-wired dual relay sockets (p/n DLS for me) that will do a host of doorlock systems, depending on application. Makes 5 wire locks like you have MUCH quicker to do, as ALL of the pin connections are done for you already. And its only a few cents more than a pair of single relay harnesses....

Posted By: gijeff1805
Date Posted: November 29, 2003 at 9:10 PM

HOLD UP! so i have to buy some relays myself, meaning that it didn't come with the alarm? if so, where can i get these relays?

-------------
JDM

Posted By: daniel2002p
Date Posted: November 30, 2003 at 9:29 PM

OK, go to a local alarm, retailer and get a DEI 451M and yes you do have to buy this and it does not come with the alarm. This unit retail for around $20-$30 and make 5-wire door lock very simple.

-------------
2005 Toyota Corolla S
1.8L VVT-i I-4
Always double check your wires with a DMM!!!
Do Not Use A Test Light!!!
MECP Certified Installer!
Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!