97 plymouth voyager remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=21754
Printed Date: April 28, 2024 at 3:43 PM
Topic: 97 plymouth voyager remote start
Posted By: letech31
Subject: 97 plymouth voyager remote start
Date Posted: November 16, 2003 at 4:54 AM
hi i want a diagram wires for plymouth voyager 1997 auto,i have autostart AS-1515 SH.any help plz
Replies:
Posted By: draasch
Date Posted: November 16, 2003 at 9:38 AM
Make: Plymouth Model: Voyager Year: 1997 This Database Was Last Updated On: 6/9/03 Index #: 6424 Alarm Constant 12 volts PINK/BLACK, RED & PINK IGNITION SWITCH HARNESS Ignition 12 volts D BLUE IGNITION SWITCH HARNESS Starter YELLOW IGNITION SWITCH HARNESS Dome Light BROWN / L GREEN (-) GRAY 36 PIN CONNECTOR AT FUSE BLOCK * Trunk Pin Switch TAN/BLACK 40 PIN NATURAL CONN. AT FUSE BLOCK Parking Lamp BLACK / YELLOW (+) GRAY 36 PIN CONNECTOR AT FUSE BLOCK Power Lock WHITE/ D GREEN BLACK 14 PIN CONNECTOR #217 Power Unlock SINGLE WIRE SYSTEM IN DRIVER KICK PANEL ** * BROWN / L GREEN (-) Wire Can Also Be Found At Headlight Switch. ** Single Wire Door Lock System, WHITE/ D GREEN Wire Requires Chassis Ground Thru A 1.5K Ohm Resistor To Lock And Chassis Ground Thru A 249 Ohm Resistor To Unlock. #217- See Single Wire Resistor Door Lock Diagram. Remote Start Tach Signal GRAY & D BLUE/TAN AT POWERTRAIN CONTROL MODULE (2.4L) * Ignition #2 BLACK/ ORANGE IGNITION SW. HARN. (HEAT/AC) #235 Ignition #3 D GREEN/ RED IGNITION SW.HARN.(TRANS CONTROL MOD.) Accessory BLACK/ WHITE IGNITION SWITCH HARNESS Neutral Safety BLACK/ WHITE (-) AT POWERTRAIN CONTROL MODULE Brake Light WHITE/ TAN (+) AT SWITCH ABOVE BRAKE PEDAL Reverse Light VIOLET/BLACK (+) BLK 10 PIN CONN. ON DR. FRONT OF ENG. Rear Window Defrost N/A TIMER BUILT INTO SWITCH * Each Wire Listed Above Is A 2 Cylinder Signal. 3.0L Tach Wire Is GRAY/RED At Powertrain Control Module (PCM). 3.3L & 3.8L Tach Wire Is GRAY/RED, D BLUE/TAN And RED / YELLOW At PCM (Each Wire Is A 2 Cylinder Signal). PCM On All Models Located On Driver Fenderwell. #235- See Powering Additional Ignitions Diagram. ------------- Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Posted By: letech31
Date Posted: November 17, 2003 at 11:15 AM
hi i need help,plz for diagram and shema for autostart as1515 sh,i have the manuel,but there is no shema.thks
Posted By: Digger67
Date Posted: November 17, 2003 at 12:09 PM
Looking for wiring diagrams for autostart try here with your AS Ser# and make of car will get you them. https://206.47.191.115/autostart.nsf
Posted By: letech31
Date Posted: November 17, 2003 at 12:31 PM
this is description for as1515 sh,but i need a diagram for this item,what means any wires plz
Posted By: derek123
Date Posted: November 17, 2003 at 2:21 PM
Posted By: letech31
Date Posted: November 21, 2003 at 3:26 PM
hi i have a starter car,model:AS1515-SH,i installed it ,but its started for 4 seconds and stopped,plz any help
Posted By: profuse007
Date Posted: November 21, 2003 at 3:35 PM
model/year of the car?
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: letech31
Date Posted: November 21, 2003 at 3:36 PM
i have plymouth voyager 1997
Posted By: profuse007
Date Posted: November 21, 2003 at 4:22 PM
| SECOND IGNITION|BLACK/ orange |+ |ignition harness |
dont forget the second igntion, see if it helps
i dont think its the tach sense, it stay for 4 sec and thats a long time. if you need to re-learn, do so.
good luck
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: letech31
Date Posted: November 21, 2003 at 4:42 PM
thks to reply but i didn't connect the tach,isn't impotrant,if yes,it was very difficult to find it in the PCM,HELP PLZ
Posted By: avxtech
Date Posted: November 21, 2003 at 4:55 PM
Tach is simple in that van, goto the fuel injector right in front of the motor.
Posted By: profuse007
Date Posted: November 21, 2003 at 5:02 PM
-injectors have 2 wires. one wire from each injector are the same, use the unique color.
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: letech31
Date Posted: November 21, 2003 at 5:07 PM
hi on the diagram for this van,i found : ignition ignition 2 ignition 3 but on the starter remote,i have just one ignition.must i connect them on the only ignition in the remote starter? about the tach,it's important to connect it or not?if yes,how do you connect it ,if it is in engin compartiment,and not near the others wires-harnnes ignition.
Posted By: letech31
Date Posted: November 21, 2003 at 6:43 PM
Posted By: profuse007
Date Posted: November 21, 2003 at 8:45 PM
the van has 2 ignitions wires
am not familiar with ultrastart at all. just use a relay and let it trigger by the ign one:
85-ground
86-run a wire from ign one
30-12volt
87-output ign 2
look at all the harness to see if you have a wire that trigger during the remote start, if so it might be neg(-):
85-that trigger wire above describe(-)
86&30-12v constant (fuse)
87-output ign 2
i dont know if tachless with work, but you have to switch the unit to tachless or else go straight with tach
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: letech31
Date Posted: November 22, 2003 at 5:17 AM
i verified the remote car starter,i found ,after i hood the remote,the ignition wire had +12v for just 4 seconds,and shutdown .is it normal?or it must had a constant +12,before i hood the stop on the remote?
Posted By: profuse007
Date Posted: November 22, 2003 at 8:45 AM
-igni wire from the unit or the car?
-if its the car, find that tach if you havent and learn it.
-if its the unit, recheck all connection. differentiate starter, ign, and accessory
***starter will stay on for certain amnt of time 4 cranking, ign will stay on aslong the rs in on, and same goes for accessory wire.
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: letech31
Date Posted: November 22, 2003 at 11:01 AM
the wire is from unit,it didn't stay on-+12v-,just for 4 s.and shut down,i didn't connect all wires when i did a try. i disconnect the unit,i did the verification at home,without car. i put +12v,and the ground,on some wires,conform to diagram,and test the ignition out,and found +12v after hood the remote,4seconds. is the unit damaged,or must connect all wires to do the test. i have as1515 sh.thks a lot of
Posted By: letech31
Date Posted: November 22, 2003 at 5:26 PM
any help plz
|