2001 Nissan Xterra Existing Hood Pin?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=21878
Printed Date: May 10, 2025 at 5:58 PM

Topic: 2001 Nissan Xterra Existing Hood Pin?

Posted By: Lockout
Subject: 2001 Nissan Xterra Existing Hood Pin?
Date Posted: November 24, 2003 at 9:23 AM

I am looking to install a combo remote start/alarm into a 2001 Nissan Xterra. The xterra has a (-)hood pin Blk/PK. Will I have to isolate the connection with a diode, or would I be better servered installing and additional hoodpin.

Same question about the door pins.

Replies:

Posted By: mobiletoys2002
Date Posted: November 24, 2003 at 9:52 AM

Use the factory switch that is already there and no diode is needed,good luck.

Posted By: mobiletoys2002
Date Posted: November 24, 2003 at 9:55 AM

In the xterra there is maybe 3 door trigger wires that all need to be connected and diode isiolated these wires are located at the secu this is a smart entrance control unit and is to the left of the brake petal. all the door lock wires and door trigger wires can be found there.

Posted By: Lockout
Date Posted: November 25, 2003 at 4:10 PM

Thanks for this info, I will be trying this this weekend. One other questions would be if someone would have a complete wire list for the 2001 Nissan Xterra

Thanks in advance

Print Page | Close Window