Some question about my prostart 5060

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=21954
Printed Date: May 09, 2025 at 8:27 AM

Topic: Some question about my prostart 5060

Posted By: swat team
Subject: Some question about my prostart 5060
Date Posted: November 25, 2003 at 4:45 PM

hi i have a 92 ford tempo V-6 with a 5-speed and i have installed some of it, my question are

1. Where do i connect my Rearm output its color is WHITE/ brown

2.Where do i connect my disarm wire its color is WHITE/ green

3.do i have to connect my ground out when running wire?

thanks

Replies:

Posted By: jrilla
Date Posted: November 25, 2003 at 6:11 PM

Did you ask this before? If not then someone else just asked the same questions abot those same three wires.

Disarm and Rearm are only for factory alarms.

Ground out when running is typically used for antigrind relays or bypass modules. You dont need any bypass modules. You could install an anti-grind relay if you choose, but it is entirely optional. Afew grinds of the starter and you wount do that again.

-------------
J Rilla

Owner/Installer

Posted By: Teken
Date Posted: November 25, 2003 at 6:39 PM

jrilla wrote:

Afew grinds of the starter and you wount do that again.

LMFAO...

LOL, I loved the way you worded that.

Regards

EVIL Teken . . .

Posted By: swat team
Date Posted: November 25, 2003 at 10:41 PM

ok thats i new here

Posted By: swat team
Date Posted: November 26, 2003 at 4:43 PM

I have a prostart 5060 and i have a couple of questions

Where do i connect my lock output its (-)

Where do i connect my unlock output its (-)

thanks

Posted By: swat team
Date Posted: November 26, 2003 at 5:32 PM

ok i was going to connect my door wires but mine lock and unlock output is postive and there my prostarts is negative what could i do??

Posted By: ck auto
Date Posted: November 26, 2003 at 10:24 PM

hi add a voltage inverter you should be able to get one that plugs into the opposite side of the brain if not you switch them with relays.

pin 30 to 12v

pin 87 to locks or unlock

pin 85 to power

pin 86 to lock\unlock on rs

good luck

kirk

Posted By: summersp
Date Posted: January 11, 2004 at 10:18 PM

My Prostart 5060 . I think I hooked it up right but when I plug it all in that alarm souds and i cant turn it off...?? anyone HELP!

Posted By: ck auto
Date Posted: January 11, 2004 at 11:20 PM

hi turn the ign 5 times on off this will put into valet mode then try programming from there i just installed one last night had to do that.if it stilll has valet button turn ign push valet

-------------
good luck
kirk

Print Page | Close Window