alarm system for an s10 Blazer

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=22116
Printed Date: May 20, 2025 at 8:04 AM

Topic: alarm system for an s10 Blazer

Posted By: West_Liberty
Subject: alarm system for an s10 Blazer
Date Posted: November 29, 2003 at 10:52 PM

I was just wandering I have an alarm for my blazer that i am going to install and it has to wires one for a 500mA channel 2 output and one for a 500mA channel 3 output where do i need to hook these wires up to or do i even need to use them?

Thanks

Replies:

Posted By: auex
Date Posted: November 30, 2003 at 9:16 AM

Those wires are for accessories like trunk pop or window modules. They don't need to be hooked up, but if you do you will probably need relays.

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Posted By: West_Liberty
Date Posted: November 30, 2003 at 12:24 PM

I have a Dual stage shock sensor for my alarm were is the best place to mount it on an s-10 blazer?

Posted By: sroth140
Date Posted: November 30, 2003 at 8:25 PM

i tied one up on a harness to the left of the steering colum, i used zipties to secure it to a trunk of wires and the piece of the dash frame right next to it.

you dont have to use those outputs for anything but if you do, make sure you use a relay. those wires are for the control circuit of a relay, they cant drive anything and if they do youll damage the brain.

Posted By: West_Liberty
Date Posted: December 01, 2003 at 9:18 PM

were exactly is the pin switch located on vehicles? and does the pre warn wire from the alarm system go to the horn?

Posted By: auex
Date Posted: December 01, 2003 at 10:45 PM

Pin switch generally refers to the door trigger, and pre warn goes to a dual zone sensor(not the horn).

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Print Page | Close Window