Print Page | Close Window

Mazda 6 alarm remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=22191
Printed Date: May 10, 2025 at 10:49 PM


Topic: Mazda 6 alarm remote start

Posted By: tlp_1977
Subject: Mazda 6 alarm remote start
Date Posted: December 01, 2003 at 2:45 PM

I need a wiring diagram for 2003 mazda 6, if any one can help.

Thanks




Replies:

Posted By: tsalas469
Date Posted: December 01, 2003 at 4:23 PM

this should do it.

12voltsblack and BLACK / YELLOW + ignition harness
StarterBLACK/ blue + ignition harness
Ignitionblue + ignition harness
Power Locklt. green - DKP or door lock module
Notes: Lock is negative trigger thru a 1.4K ohm resistor. Unlock is a straight negative trigger. MUST use relays.

The door lock control module is located above the passenger kick panel.
Power Unlocksame wire as power lock   
Lock MotorRED / blue 5wiDKP or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Unlock MotorRED / green 5wiDKP or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Disarm DefeatRED / black 5wiDKP or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Parking Lights+lt. GREEN/ black + driver kick, 14 pin plug
Parking Lights-RED / white - headlight switch
Hazardsblue/orange - switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Turn Signal(L)WHITE/ black + steering column
Turn Signal(R)WHITE/ red + steering column
Door TriggerGREEN/ orange - DKP or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Dome Supervisionyellow/black - DKP or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Trunk/Hatch Pinbrown - DKP or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Hood Pingray/red - pin switch or theft module
Notes: The theft-deterrent control module is located in the center console.
Trunk/Hatch Releaseyellow - switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Power Sliding DoorN/A   
Factory Alarm Armblue - DKP or door lock module
Notes: Arm is negative trigger thru a 1.4K ohm resistor. Disarm is a straight negative trigger. MUST use relays.

The door lock control module is located above the passenger kick panel.
Factory Alarm Disarmsame wire as alarm arm   
Disarm No Unlockuse key sense wire   
TachometerNOT blk/wht or grn/stripe ac ignition coil or coil pack
Notes: On the 4 cyl models use the wire that is NOT BLACK/ white. On the 6 cyl models use the wire that is NOT GREEN/ stripe.
Horn TriggerPURPLE / white - column or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Memory Seat 1N/A   
Memory Seat 2N/A   
Memory Seat 3N/A   
posted_image
Immobilizer Bypass Module:Required: YesType: TransponderPart #: 555U
Notes: N/A




Posted By: tlp_1977
Date Posted: December 04, 2003 at 11:34 AM

Thanks for all the help.




Posted By: freakystyley990
Date Posted: December 08, 2003 at 2:30 AM
This is not the correct wiring chart. While the keyless module IS above the passenger kick panel, the lock wires are not 5-wire. Lock is a straight negative trigger, and unlock is negative trigger, but requires a resistor. However, you must use relays for both. I do not remember the resistance value. Also, the factory disarm wire can be found at this module as well.


Print Page | Close Window