programming CT 3300
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=22429
Printed Date: May 10, 2025 at 10:42 PM
Topic: programming CT 3300
Posted By: chrisjo
Subject: programming CT 3300
Date Posted: December 06, 2003 at 9:45 AM
I read the other posts about CT 3300, tried everything but still can't get the darn thing to work! I installed it in a 200 F150, hooked up everything, but now I can't program the transmitter. I followed the steps as described in the guide, but at the end of the procedure, the lights won't flash 5 times.
Replies:
Posted By: Velocity Motors
Date Posted: December 06, 2003 at 9:49 AM
The ProStart 3300 ( actually all the ProStart's ) are VERY, VERY hard to program. You have to sit there in your car and try it about 1000 times before you might get it to program once. Keep going through the program sequence until it learns the transmitter. I know that's not much help, but it does work for the ProStart's .
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: chrisjo
Date Posted: December 06, 2003 at 8:58 PM
 Well, I tried, not 1000 times, but dozens of times - nothing. Anybody out there that can help me?
Posted By: Falcon 1
Date Posted: December 06, 2003 at 10:45 PM
Reset the module then as your cycling the key on/off push the lock button as it says in the manual. ------------- Do it right the first time, only a doctor can bury his mistakes.
Posted By: ck auto
Date Posted: December 07, 2003 at 10:26 AM
hi make sure you press lock twice and hold on second press if that doesn't work press it a couple of times ive done alot of prostarts for canadian tire and don't have a problem with them just a little tricky to get remote programmed but always get it after 2 or 3 tries good luck kirk
Posted By: chrisjo
Date Posted: December 07, 2003 at 4:45 PM
 Thanks Falcon 1! The trick was to press the lock button WHILE I was turning ignition off-on-off. The truck starts now but I can't operate the power door locks with the remote and I guess I have to get a bypass module because it starts only with key in cylinder. - Thanks again!
Posted By: Falcon 1
Date Posted: December 07, 2003 at 4:58 PM
Glad I can help chrisjo I have been doing those that way now and it always seems to work. ------------- Do it right the first time, only a doctor can bury his mistakes.
|