Crimestopper CS2015fm on 01 Durango

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=22714
Printed Date: November 04, 2025 at 5:12 AM

Topic: Crimestopper CS2015fm on 01 Durango

Posted By: carrman
Subject: Crimestopper CS2015fm on 01 Durango
Date Posted: December 11, 2003 at 6:12 PM

My question is that I have seen three different ways to do the door locks. I have keyless entry and no alarm. If someone is familiar with this alarm and could help with the correct wires, I would very much appreciate it......Thanks, James

Replies:

Posted By: draasch
Date Posted: December 11, 2003 at 10:28 PM

Power Lock WHITE/ D GREEN *** 14 PIN CONN. IN DR #217
Power Unlock SINGLE WIRE SYSTEM KICK OR CTM *

*** WHITE/ D GREEN Wire Must See Ground Through 820 Ohm Resistor To Lock And Ground through 320 Ohm Resistor to Unlock. Resistance Values Are +/- 2% #217 - See Single Wire Resistor Door Lock Circuit.

* Central Timer Module (CTM) Located In Driver Kick Panel

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: carrman
Date Posted: December 12, 2003 at 5:41 PM

Thanks for the help.....James

Posted By: carrman
Date Posted: December 13, 2003 at 1:36 PM

I'm having trouble finding a 320ohm or 820ohm resistor for my 01 durango. Any help is appreciated.

Thanks,

James

Posted By: auex
Date Posted: December 13, 2003 at 1:37 PM

What resistor can you find? There are multiple ways to get those values if you can't find the actual resistor.

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Posted By: carrman
Date Posted: December 13, 2003 at 1:58 PM

I found 1k, 200, 300, but I don't know if I need 1/2 or 1/4w.

Thanks,

James

Posted By: auex
Date Posted: December 13, 2003 at 2:12 PM

1/4 watt is fine. The three hundred should be close enough to the 320 to work, for the 82 take two 1K resistors and wire those parrellel (giving you 500 ohms) and take a three hundred and wire is in series to the 2 1K resistors giving you 800 ohms, these should be close enough to what you need to work.

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Posted By: carrman
Date Posted: December 13, 2003 at 4:01 PM

Thank You, I'll give it a try.

James

Posted By: carrman
Date Posted: December 23, 2003 at 9:18 PM

My Crimestopper 2015FM has an Ignition, Accessory, or 2nd Ign/ ACC for remote start. My diagram lists Ign/blue-2nd Ign GREEN/ red-ACC BLACK/ orange-2nd ACC green, so I have the green wire left over. Do I need this? Any help is appreciated.

James