AutoPage 850LCD

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=22770
Printed Date: June 30, 2025 at 4:19 AM

Topic: AutoPage 850LCD

Posted By: LSIDONIS
Subject: AutoPage 850LCD
Date Posted: December 12, 2003 at 9:18 PM

The H8/8 Pink Wire is a programable output for either 2 stage unlock OR OEM disarm. I need both. Any way around this?

Thanks.

Replies:

Posted By: HamiltonAudio
Date Posted: December 14, 2003 at 1:33 PM

you want the 2 stage unlock AND a disarm signal? try using the first unlock pulse wire (they will be separate) and split it with diodes to disarm the alarm. Hence, on the first unlock, the system pulses negative to unlock and disarm at the same time...

Posted By: LSIDONIS
Date Posted: December 15, 2003 at 9:42 AM

Thanks for the info. But I also need the disarm for remote start.

Posted By: jrilla
Date Posted: December 15, 2003 at 10:32 AM

Isnt that stupid? I thought they would have changed that from the 750, but I guess not.

What vehicle? There may be another way to disarm for remote start. There may be an easier way once i know what vehicle, but you could use a constant to momentary relay setup using a cap and a resistor as shown in the relays section.

-------------
J Rilla

Owner/Installer

Print Page | Close Window