94 Nissan Remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=22804
Printed Date: May 12, 2025 at 2:19 PM
Topic: 94 Nissan Remote start
Posted By: JohnnyK705
Subject: 94 Nissan Remote start
Date Posted: December 13, 2003 at 5:18 PM
I have a 97 Nissan Altima, I just installed a crimestopper cs-2011 IV. The automatic locks work with the factory switchs, but not with the alarm remote, the diodes are in place and are wired (-) correctly. [lock is a grey wire on right side of steering column and unlock is a purple wire that I tapped into the left front door] Also I am not sure how to bypass the stock security system, the stock system doesnt have any remotes, just the word security with a blinking red light. I I believe I am supposed to use the orange and black wire, and I think I am supposed to connect it to the green and yellow factory disarm GRN/YEL (-) that is located at the smart entry cont unit, but am not quite sure where that is. Am I supposed to ground out any wires if I dont use them. When I hit the remote start the car starts but the siren is also going off with it. I ve installed several alarms and am getting frustrated with this one, not sure, maybe brain is bad, please help me
I have left the following wires disconnected
Pink to glowplug ONLY for diesels
blue (-) hood or trunk switch
Violet (+) door switch
Red for door lock relays
ORANGE / black (-) oem disarm
Orange (-) armed output (500ma)
Blue/White (-) passenger unlock Optional
Blue/black (-) IGN or Aux #2 (500ma)
GREEN/ red aux output or (-)map output Optional
BLACK/ White (-)neg Dome Light (500ma) Optional
BROWN / White (-) horn honk (500ma) Optional
Pink/White ignition or accessory #2 output
-------------
Johnny K
Replies:
Posted By: jrilla
Date Posted: December 13, 2003 at 8:20 PM
POWER LOCK gray/blue
POWER UNLOCK gray/red
Located at door lock timer which is a blk or grn box located right of fusebox behind a silver module or up high in the drivers kick behind a silver module, depending on model. Two plugs, white and black. The wires needed to control locks are in the black plug.
Factory ARM lt. GREEN/ red
Factory DISARM GREEN/ YELLOW
in the harness from drivers door. Hook your ORANGE / Black to the disarm wire, and diode isolate your lock wire with band of diode facing the unit and then go to lock and the arm wire. Arming is optional.
-------------
J Rilla
Owner/Installer
|