Keyless entry 92 Ford explorer

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=22827
Printed Date: May 15, 2025 at 5:24 AM

Topic: Keyless entry 92 Ford explorer

Posted By: JohnnyK705
Subject: Keyless entry 92 Ford explorer
Date Posted: December 14, 2003 at 9:28 AM

I installed a keyless entry/remote start in my 92 Ford Explorer. The remote start works fine but I tapped in to the wires right off the master switch for the locks, I cant seem to get them to operate with the remote is there anyone who can help and guide me in the right direction

-------------
Johnny K

Replies:

Posted By: draasch
Date Posted: December 14, 2003 at 9:49 AM

Power Lock PINK / YELLOW DRIVER KICK #203
Power Unlock PINK/LIGHT GREEN PANEL * #201

* Without OEM Keyless See Note #203, With OEM Keyless See Note #201. #203- See Reversal Rest At Ground Door Lock Diagram. #201- See Negative Pulse Door Lock Diagram.

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: jrilla
Date Posted: December 14, 2003 at 10:32 AM

You likely have reverse polarity door locks since iy is more likely to not have factory keyless in 92. In this case the locks will test positive but then you need to cut the factory wires and install relays in between.

Pin 87a goes to the switch side of the cut wire, Pin 87 and 86 get 12v+ constant fused, Pin 30 gets the actuator side of the cut wire, and then Pin 85 gets the respective (-) lock or unlock output from the key less entry unit you are installing.

-------------
J Rilla

Owner/Installer

Posted By: draasch
Date Posted: December 14, 2003 at 2:16 PM

johnny, you can also get a DLS and wire that up if u have the RP dool locks.it might be easiser and faster for you...........

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt