Print Page | Close Window

2003 Dodge 1500 Hemi remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=22991
Printed Date: May 01, 2024 at 9:45 PM


Topic: 2003 Dodge 1500 Hemi remote start

Posted By: Slcoo3
Subject: 2003 Dodge 1500 Hemi remote start
Date Posted: December 17, 2003 at 5:18 PM

I'm looking for the wiring diagram for the 2003 Hemi. Can any one help?



Replies:

Posted By: Geeque
Date Posted: December 17, 2003 at 5:28 PM
2 dr or ext cab?

-------------
Gary Kline
MECP Master Technician




Posted By: Slcoo3
Date Posted: December 17, 2003 at 5:35 PM
 The trucks a 2 dr.




Posted By: Geeque
Date Posted: December 17, 2003 at 6:15 PM

Dodge

Ram Pickup

2002-2004

Remote Starter  Wiring Colors and Notes

Function

 

Vehicle  Color

Location

Start:

 

YELLOW

IGNITION SWITCH HARNESS

Ignition  #1:

 

BLUE (16 AWG)

IGNITION SWITCH HARNESS

Ignition #2:

 

RED

IGNITION SWITCH HARNESS

Ignition  #3:

 

GREEN & ORANGE (2 WIRES)

IGNITION SWITCH HARNESS

Accessory:

 

BLACK/ WHITE & BLUE (2 WIRES)

IGNITION SWITCH HARNESS

Brake  Light:

 

WHITE/ TAN

AT SWITCH ABOVE BRAKE PEDAL

Tach  Signal:

 

TAN/RED

AT IGNITION COIL

Parking Lights:

 

PURPLE / YELLOW

HEADLIGHT SWITCH*

Headlights:

 

PURPLE / YELLOW

HEADLIGHT SWITCH *

OEM Alarm  Disarm:

 

LT. GREEN/ ORANGE *****

HARNESS COMING IN FROM DRIVER'S DOOR

OEM Alarm  Arm:

 

Diesel  Glow Plug:

 

ORANGE / Black

Powertrain Control Module***

Clutch  Bypass Wire:

 

Notes:

 * This Is A Single Wire System. Parking Lights Need To See A Ground (-) Through A 330 Ohm Resistor. Headlights Need To See A Ground (-) Through A 700 Ohm Resistor. ** Diesel Vehicles - ORANGE / Black Wait to Start; Tach Wire Is Gray/Black. Both Wires Are Located In A Black Connector Center Top Of Fire Wall. There Are Two Black Connectors, The Correct One Does Not Have A White Insert. *** Tach can also be located at pin 74 behind instrument cluster.

Dodge

Ram Pickup

2002-2004

Alarm and Keyless  Entry Wiring Colors and Notes

Function

 

Vehicle  Color

Location

Constant  +12 Volts:

 

PINK/BLACK

IGNITION SWITCH HARNESS

Starter  Kill:

 

YELLOW

IGNITION SWITCH HARNESS

Ignition  +12 Volts:

 

BLUE (16 AWG)

IGNITION SWITCH HARNESS

Dome  Lights/Superv:

 

SEE NOTE ***

OEM Horn:

 

BLACK/ RED (-)

STEERING COLUMN HARNESS

Power  Lock:

 

WHITE/ GREEN

DRIVER'S KICK PANEL ****

Power  Unlock:

 

WHITE/ GREEN

DRIVER'S KICK PANEL ****

Trunk  Release:

 

N/A

Alarm  Input Wire:

 

SEE NOTE ***

Notes:

*** Separate Triggers For Each Door. The Driver's Door Trigger Is Tan (-). The Left Rear Door Trigger Is Tan/Orange (-). Both Wires Can Be Found In The Driver's Kick Panel. The Passenger Front Door Trigger Is Tan/Red (-) And the Passenger Rear Door Trigger Is Tan / YELLOW (-). Both Of These Wires Can Be Found In The Passenger Kick Panel. Diode Isolate Each Wire For Alarm Trigger With The Bands Facing Away From The Alarm/Remote Start Module. Use Only One Trigger For Dome Light Supervision. **** Single Wire Door Lock System See Note #211. Lock Requires A Ground (-) Pulse Through A 867 Ohm Resistor. Unlock Requires A Ground (-) Pulse Through A 364 Ohm Resistor. Diode Isolate One Of The Wires. ***** Requires A Negative Pulse Through A 1.5 K-Ohm Resistor.

DesignTech  International, Inc.

Tel: (703)  866-2000 Fax: (703) 866-2001

©2002  All Rights Reserved

7955 Cameron  Brown Court
Springfield, Virginia 22153 USA

1-800-DESIGNTECH
(1-800-337-4468)

DesignTech  International, Inc.
www.designtech-intl.com

DesignTech disclaims any liability or responsibility arising out of any inaccuracies of this information or use of this
information for installations or otherwise. Please verify all wiring for accuracy prior to making any connections.



-------------
Gary Kline
MECP Master Technician




Posted By: Geeque
Date Posted: December 17, 2003 at 7:03 PM
Should be the same.

-------------
Gary Kline
MECP Master Technician




Posted By: auex
Date Posted: December 17, 2003 at 7:13 PM
Hey Geeque, as far as posting your designtech diagram's, you may want to delete the bottom portion of the diagram.
You know the part that says "©2002 All Rights Reserved"



-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.




Posted By: Geeque
Date Posted: December 17, 2003 at 7:15 PM
Thanks just trying to help!

-------------
Gary Kline
MECP Master Technician




Posted By: Geeque
Date Posted: December 17, 2003 at 7:16 PM
Let them sue me!!!!

-------------
Gary Kline
MECP Master Technician




Posted By: securinu
Date Posted: December 17, 2003 at 10:50 PM
Also the 2004 is completely different All new colors. 02 and 03 are the same

-------------
Joe O'Byrne
Owner / Installer




Posted By: Slcoo3
Date Posted: December 25, 2003 at 1:09 PM
Will I need an immobilizer ?




Posted By: Slcoo3
Date Posted: December 25, 2003 at 1:11 PM
Where can I find these resistors?




Posted By: Slcoo3
Date Posted: December 25, 2003 at 1:12 PM
Where can I buy the resistors?




Posted By: Velocity Motors
Date Posted: December 25, 2003 at 1:26 PM
At any electronics repair shop or you can contact us and we can ship some out to you as well.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: Velocity Motors
Date Posted: December 25, 2003 at 1:29 PM
If you have a grey headed key, then you require a bypass module for this vehicle. We sell the door lock, alarm and Sentry key bypass module for this vehicle. This way you don't need the resistors and everything is wired through the databus wire instead of through relays, resistors & such.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA





Print Page | Close Window