Does any one know the best place to access the ignition harness to install a remote start ...Also any pointers you may have for the installation process would be greatly appreciated....Thank you
Make: Volkswagen
Model: Jetta
Year: 2003
This Database Was Last Updated On: 6/9/2003
Index #: 5092
Alarm
Constant 12 volts WHITE/ RED IGNITION SWITCH HARNESS
Ignition 12 volts BLACK IGNITION SWITCH HARNESS
Starter RED / BLACK IGNITION SWITCH HARNESS
Dome Light RED / BLACK (-) DRIVERS A PILLAR
Trunk Pin Switch BROWN / WHITE (-) DRIVERS KICK PANEL
Parking Lamp GRAY/BROWN (+) AT HEADLIGHT SWITCH
Power Lock RED / BLUE DRIVERS KICK #201
Power Unlock RED / LT.GREEN PANEL
#201 See Negative Pulse Door Lock Diagram
Remote Start
Tach Signal GREEN/ YELLOW AT IGNITION COIL #239
Ignition #2 BROWN / RED IGNITION SWITCH HARNESS
Ignition #3
Accessory BLACK/ RED IGNITION SWITCH HARNESS
Neutral Safety
Brake Light RED / BLACK (+) AT SWITCH ABOVE PEDAL
Reverse Light BLACK/ BLUE (+) DRIVERS KICK PANEL
Rear Window Defrost
#239 See Immobilizer Bypass Diagram
https://wiringinstructions.com/239.htm
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
ok I have been under the dash of this vehicle and getting to what I think might be the ignition harness is almost impossible the wires are so tight I can not see what is in the middle of the harness I did not know if there was a better place to access these wires ..the harness i found was running above the steering column on the rigfht hane side ???? I do appreciate the wiring specs but that is not the problem......
Did you take the shroud off the column? it should be right there rather easy to access and even unplug if you want.
-------------
J Rilla
Owner/Installer
I have already installed the bypass unit........... at that point I had the shroud off but only the top because the bottom has screws behind the steering wheel and I was trying to avoid removing that from the car are there any other suggestions???????