request for Celica 94 Alarm Wiring please
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=23391
Printed Date: May 24, 2025 at 1:32 PM
Topic: request for Celica 94 Alarm Wiring please
Posted By: legend9
Subject: request for Celica 94 Alarm Wiring please
Date Posted: December 26, 2003 at 9:02 PM
Hi, Does anyone have the diagram for the celica 94 ? Please show me if you have it. Thanks.
-------------
Made in Japan
Replies:
Posted By: Teken
Date Posted: December 26, 2003 at 9:07 PM
Start: BLACK/ WHITE IGNITION SWITCH HARNESS
Ignition #1: BLACK/ ORANGE IGNITION SWITCH HARNESS
Ignition #2: BLUE/RED IGNITION SWITCH HARNESS
Accessory: GRAY IGNITION SWITCH HARNESS
Brake Light: GREEN / WHITE (+) AT SWITCH ABOVE BRAKE PEDAL
Tach Signal: GRAY AT IGNITER OR CHECK CONNECTOR *
Parking Lights: GREEN (+) AT FUSE/JUNCTION BLOCK ('TAIL'FUSE)
Headlights: RED / GREEN (-) AT HEADLIGHT SWITCH
Notes:
* Igniter And Check Connector Located In Driver Rear Corner Of Engine Compartment.
--------------------------------------------------------------------------------
Toyota
Celica
1994-1995
Alarm and Keyless Entry Wiring Colors and Notes
Function
Vehicle Color
Location
Constant +12 Volts:
WHITE AND BLACK/ RED
IGNITION SWITCH HARNESS
Starter Kill:
BLACK/ WHITE
IGNITION SWITCH HARNESS
Ignition +12 Volts:
BLACK/ ORANGE
IGNITION SWITCH HARNESS
Dome Lights/Superv:
RED / WHITE
(-) AT FUSE/JUNCTION BLOCK
OEM Horn:
GREEN
(-) STEERING COLUMN HARNESS
Power Lock:
BLUE/BLACK
DRIVER'S KICK PANEL **
Power Unlock:
BLUE
DRIVER'S KICK PANEL **
Trunk Release:
N/A
Alarm Input Wire:
RED / WHITE
(-) AT FUSE/JUNCTION BLOCK
Notes:
** Child Safety Locks: GREEN (-) In Same Conn. As Door Lock Wires Above. See Note # 209 - Child Safety Door Lock Diagram.
Posted By: legend9
Date Posted: December 27, 2003 at 10:48 AM
Thanks a lot. =)
-------------
Made in Japan
Posted By: Teken
Date Posted: December 27, 2003 at 11:21 AM
Please varify *ALL* provided wiring codes with your DMM, and in the appropiate running modes of operation.
ie. Ignition location & varification = Will show +12 volts in the on / run position, AND crank / start.
You will varify this wire at least (2) times, with turning the key to the off position.
Please take your time, and be like a wood cutter, measure twice, cut once.
Regards
EVIL Teken . . .
|