Print Page | Close Window

2003 Jeep Liberty Sport 3.7L V6

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=23396
Printed Date: June 02, 2024 at 3:35 AM


Topic: 2003 Jeep Liberty Sport 3.7L V6

Posted By: cdawg925
Subject: 2003 Jeep Liberty Sport 3.7L V6
Date Posted: December 26, 2003 at 9:43 PM

Hello... Does anyone out there have a wiring diagram for a remote starter/stereo for a 2003 Jeep Liberty Sport 3.7L V6?  Thanks!




Replies:

Posted By: Teken
Date Posted: December 26, 2003 at 10:24 PM

Jeep

Liberty

2002 - 2003

Remote Starter Wiring Colors and Notes

Function
   Vehicle Color
Location

Start:
   YELLOW
IGNITION SWITCH HARNESS *

Ignition #1:
   RED / BLUE
IGNITION SWITCH HARNESS

Ignition #2:
   BLACK/ ORANGE
IGNITION SWITCH HARNESS

Ignition #3:
   N/A


Accessory:
   BLACK/ WHITE
IGNITION SWITCH HARNESS

Brake Light:
   WHITE/ TAN
AT SWITCH ABOVE BRAKE PEDAL

Tach Signal:
   TAN/RED
AT COIL # 1

Parking Lights:
   LT. GREEN/ ORANGE (-)
AT HEADLIGHT SWITCH**

Headlights:
   N/A


OEM Alarm Disarm:
   LT. GREEN/ ORANGE
DRIVER'S KICK PANEL ***

OEM Alarm Arm:
   LT. GREEN/ ORANGE
DRIVER'S KICK PANEL ***

Diesel Glow Plug:
   N/A


Clutch Bypass Wire:
   


Notes:
   * This vehicle may be equipped with Chrysler's Smart Key Transponder Theft System Only If The Ignition Key Is Gray. Use Universal Alarm Bypass Module part # 2x402 where X can be any number. You may also use vehicle specific bypass module part # 23568. ** Must use a relay to supply a ground pulse through a 900 Ohm resistor. *** Single Wire System. A Negative Pulse Through A 475 Ohm Resistor Will Disarm The Alarm. A Negative Pulse Through A 2 K-Ohm Resistor Will Arm The Alarm.

--------------------------------------------------------------------------------

Jeep

Liberty

2002 - 2003

Alarm and Keyless Entry Wiring Colors and Notes

Function
   Vehicle Color
Location

Constant +12 Volts:
   PINK/BLACK
IGNITION SWITCH HARNESS

Starter Kill:
   YELLOW
IGNITION SWITCH HARNESS *

Ignition +12 Volts:
   RED / BLUE
IGNITION SWITCH HARNESS

Dome Lights/Superv:
   YELLOW
AT COURTESY LIGHT UNDER DASH ***

OEM Horn:
   BLACK/ RED (-)
STEERING COLUMN HARNESS

Power Lock:
   PINK/VIOLET
DRIVER'S KICK PANEL ****

Power Unlock:
   PINK/VIOLET
DRIVER'S KICK PANEL ****

Trunk Release:
   ORANGE / BROWN (+)
AT BCM THAT’S INTEGRATED INTO THE FUSE PANEL

Alarm Input Wire:
   YELLOW
AT COURTESY LIGHT UNDER DASH ***

Notes:
*** Use For Alarm Pulse Only. For Domelight Supervision, Use Either A Tan (-) or Tan/White (-) Wire Located In A Blue Plug To The Right Of The Steering Column. These Are The Driver's And Passenger Door Pulses Respectively. **** Single Wire System. A Negative Pulse Through A 1.4 K-Ohm Resistor Will Lock The Doors. A Negative Pulse Through A 425 Ohm Resistor Will Unlock All The Doors. See Note #211 Single Wire Negative Trigger Door Locks.




Print Page | Close Window