2003 Silverado and the 456G
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=23701
Printed Date: May 06, 2024 at 8:49 AM
Topic: 2003 Silverado and the 456G
Posted By: birdslam
Subject: 2003 Silverado and the 456G
Date Posted: January 01, 2004 at 9:53 AM
Hi, I have done alot of reading and still don't fully understand what the 456G is needed for when installing a remote start with keyless entry. My plans are to install the DEI (or Viper) 554R and sounds like I need the 555L bypass module. That part sounds easy. What I want to know is there a way to get the lock/unlock to work without using the 456G? I don't want to spend an extra $50 for this module if it gains me nothing as far as lock/unlock goes. I don't however want to take my door panel off (because every door panel I have ever taken off rattles after re-installed) and if I need to do this to get the lock/unlock to work with the 554R then I will just buy the additional 456G module and get it over with. Any suggestions are appreciated and also for my history I have put in a few astrostarts in older vehicles so let me know if doing a 2003 with these 3 modules is much more complex. Thanks
Replies:
Posted By: ck auto
Date Posted: January 01, 2004 at 10:54 AM
the 555g tires into thedatabuss wire for thelock there are better modules out there that o passlock security disarm rearm heated seats and window up alll in one module i think the autostart #is gm dl7
-------------
good luck
kirk
Posted By: ck auto
Date Posted: January 01, 2004 at 10:55 AM
the 555g ties into the databuss wire for the lock and unlock and disarm rerarm there are better modules out there that do passlock security disarm rearm heated seats and window up alll in one module i think the autostart #is gm dl7
-------------
good luck
kirk
Posted By: birdslam
Date Posted: January 01, 2004 at 11:42 AM
So the 555G or the GM D17 will take the place of BOTH the 555L and the 456G??? That sounds better if true.
Posted By: ck auto
Date Posted: January 01, 2004 at 12:01 PM
yes thats right and the dl7 does it all through the data wire so no cutting passlock wires like the 555l which can cause problems. ------------- good luck
kirk
Posted By: birdslam
Date Posted: January 01, 2004 at 1:54 PM
I did some google searching and can't find this DL7 or DI7 that you mention. Do you have a site or a correct part number?? Thanks
Posted By: ck auto
Date Posted: January 01, 2004 at 6:53 PM
hi this is the site i came up with but just go to your local autostart dealer or check a few shops till you find one i think i paid about $45 for the bypass https://www.bypasskit.com/proddetails.asp?prodid=MULTIDL------------- good luck
kirk
Posted By: birdslam
Date Posted: January 01, 2004 at 10:23 PM
GREAT!! Thanks for the info. Sounds like the GMDL-BP, GMDL-4 or the MultiDL will work for me. If anyone knows a place to order one online let me know. Couldn't find them online and I am not a dealer so can't order from bypasskit.com Thanks again CK Auto.
Posted By: JWorm
Date Posted: January 01, 2004 at 11:52 PM
www.autotoys.com
Look in the remote start section under databus doorlock interfaces.
Posted By: rudbwoy69camaro
Date Posted: January 02, 2004 at 12:32 AM
yessss, that databus kit IS it.
-------------
|