I need a wiring color and location chart for a 1995 Dodge Intrepid.
Thanks
| DODGE INTREPID 93-95 |
| WIRE | COLORS | LOCATION |
| 12 VOLTS CONSTANT | RED | IGNITION SWITCH HARNESS |
| IGNITION 1 | D BLU | IGNITION SWITCH HARNESS |
| IGNITION 2 | RED / WHT | IGNITION SWITCH HARNESS |
| ACCESSORY /HEATER BLOWER 1 | BLK/ORG | IGNITION SWITCH HARNESS |
| STARTER | YEL | IGNITION SWITCH HARNESS |
| PARKING LIGHTS | BLK/YEL(+) | BLACK CONNECTOR LEFT OF STEER COLUMN |
| DOMELIGHT | TAN and TAN/RED (-) | DRIVERS AND PASSENGERS KICK PANELS. *SEE NOTES BELOW* 1 |
| PWR DOOR LOCK | ORG/WHT | L BLU 12 PIN CONN |
| PWR DOOR UNLOCK | PNK/VIO | ON BACK OF FUSE BLOCK (TYPE A) |
| TRUNK RELEASE | BLK/WHT (+) | AT RELEASE SWITCH |
| TACH SENSOR | RED or WHITE or BLACK (AC) | COIL PACK ON ENG |
BRAKE | WHT/TAN(+) | AT SWITCH |
HORN | BLK/RED (-) | STEER COLM |
FACTORY DISARM | L GRN/ORG(-) | BLK 16 PIN CONN IN DRV KICK PANEL |
NOTES:
*1 - Tan gets drivers door, tan/red gets pass. doors. Tap both wires and diode isolate.
Make: Dodge
Model: Intrepid
Year: 1993-95
This Database Was Last Updated On: 6/9/2003
Index #: 1492
Alarm
Constant 12 volts RED & PINK/BLACK IGNITION SWITCH HARNESS
Ignition 12 volts DARK BLUE IGNITION SWITCH HARNESS
Starter YELLOW IGNITION SWITCH HARNESS
Dome Light YELLOW (-) PIN SWITCH OR 12 PIN CON-DRV KICK
Trunk Pin Switch TAN/BLACK (-) DRIVER KICK PANEL - 12 PIN CONNECTOR
Parking Lamp BLACK / YELLOW @ LT SW. (+) OR BLK CONN-LEFT OF STEERING COLM
Power Lock ORANGE / WHITE IN LT.BLU 12-PIN CONNECTOR #202
Power Unlock PINK/VIOLET ON THE BACK OF FUSE BOX
#202- See Positive Pulse Door Lock Diagram
Remote Start
Tach Signal GRAY, RED / YELLOW, BLUE / YELLOW @ COIL PACK ON ENGINE *
Ignition #2 RED / WHITE IGNITION SWITCH HARNESS (AIRBAG) #235
Ignition #3 BLACK/ ORANGE IGNITION SWITCH HARNESS (HEAT/AC)
Accessory BLACK/ WHITE IGNITION SWITCH HARNESS (WIPER/RADIO)
Neutral Safety BLACK/ GREEN GEAR SELECT SWITCH
Brake Light WHITE/ TAN (+) AT SWITCH
Reverse Light VIO/BLK OR BLK/LT GRN (+) AT SWITCH ON TRANSMISSION
Rear Window Defrost
* Each Wire Listed Above Is A 2 Cylinder Signal. Wire Colors In Late Production Models Are RED, WHITE & BLACK At Coil Pack. #235- See Powering Extra Ignitions Diagram
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
I'm confused guys. I have a 1994 Intrepid, so that's why I'm looking at this topic. One of you said that the Tachometer wire is either Red, Black, or White located at the coil pack on the ENG. But draasch says that it is a Grey, RED / Yellow, or Blue / YELLOW wire located at the coil pack on the ENG.
Can either of you site your source as to why your information differs? Or does anyone else here know why the difference in information, or which wire it actually is? Reason I ask is that I need this wire in the current installation that I am doing.
Also, I have another question: Why could it be any of three wires? Did Dodge not standardize these wires from year to year?
Thanks
It can be any of these colors because it is on the coil pack. One for each of the cylinder's of the vehicle. The information that I have is red, white, or black. I did a 1994 Eagle Vision the other day and I used the white wire on the coil pack located on the side of the engine ( driver's side ) low beside the plug wires.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA